User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Installing mast mounts
- Ch 4 - Installing ODUs
- Ch 5 - Installing IFL cables
- Ch 6 - Indoor equipment
- Ch 7 - Commissioning HTs
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating IFL cables
- Index
1027145–0001 Revision E 4–16 Installing ODUs Hub installation
Attach the antenna to the mount as follows:
1. With the antenna radome facing in the direction of the
assigned HT sector, position the round, flat surface of the
antenna bracket approximately 1 inch (2.5 centimeters)
from the mast interface.
2. Rotate the antenna approximately 45° away from the HT
alignment direction (assigned sector) until the antenna
bracket reliefs (curved indentations) are aligned with the
four nuts on the mast interface, as shown in figure 4-11.
T0006033
45
Alignment direction
Antenna
Mast
interface
Antenna
bracket
Antenna bracket
locking nut (1 of 4)
Close-up view:
Antenna bracket reliefs (4)
Relief
Figure 4-11 Rotating the antenna so the antenna
bracket can be placed against the mast interface
3. Press the antenna against the mast interface.
Attaching the antenna