User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Installing mast mounts
- Ch 4 - Installing ODUs
- Ch 5 - Installing IFL cables
- Ch 6 - Indoor equipment
- Ch 7 - Commissioning HTs
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating IFL cables
- Index
1027145–0001 Revision E Installing ODUs 4–13Hub installation
Follow the steps below to install the antenna mount.
1. Determine which side of the mast clamp to use:
T0009024
Mast clamp
Use this side against the mast if the
mast outside diameter is
.
less than
3.5 inches (8.9 centimeters)
Use this side against the mast if the
mast outside diameter is 3.5 inches
(8.9 centimeters) or larger.
2. One side of the mast clamp has two open–end bolt holes
that allow the long bolts that are attached to the mast
interface to swing in or out. See figure 4-8. At the side of
the mount where the two open–end bolt holes are, swing the
two bolts outward so you can open the mount enough to
place it around the mast.
T0009032
Open-end
bolt hole
Figure 4-8 Opening the mount
4.5
Installing the
antenna mount