User's Manual

1027145–0001 Revision E Index-1
Index
A
Abbreviations (identified), A- 1
Access, buildings and equipment locations, 2–2
Acronyms (identified), A- 1
Adding SSIs, 10–2
Adjusters for antenna azimuth and elevation,
4–11, 4–22
Aligning the HT antenna, 4–6
Antenna
adjusting azimuth, 4–18
fine adjustment, 4–22
adjusting elevation, 4–20
fine adjustment, 4–22
attaching to the antenna mount, 4–15
replacing, 10–6
Antenna bracket, changing left–right orientation,
4–15
Antenna mount
installing, 4–10, 4–13
parts (illustrated), 4–10
torque, 4–19, 4–21
torque wrench, 4–5
AT M . See OC3c–ATM SSI
Azimuth
adjusting, 4–18
fine adjustment, 4–22
explained and illustrated, 4–18
Azimuth/elevation adjusters. See Adjusters (to
adjust azimuth or elevation)
B
Ballast. See Concrete blocks
Bend radius (IFL cable), 5–7, 5–13
Blocks. See Concrete blocks (ballast)
Boot message, 7–5
Boot up sequence, 7–5
Buttons on CCM, 6–35
functions, 6–36
C
Cable length
DS3–TDM SSI, 6–28
DS3–transparent SSI, 6–29
IFL, 5–4
OC3c–ATM SSI, 6–29
Canadian Interference–Causing Equipment
Regulations, B–2, B–3
Canadian Standards Association, B–2, B–3
CCM
See also LCD
Boot message, 7–5
boot up sequence, 7–5
button functions, 6–36
buttons on front panel, 6–35
configuration downloading, 7–6
devices, 7–5
functions, 6–26
illustrated (front panel), 6–26
installing, 6–26
interfaces (clock and LAN), 6–28
LEDs, 6–37
indications, explained, 6–28
operational state, 7–6
power–on test, 6–37
replacing, 10–10
software downloading, 7–6
status, 7–7
SUDS, 6–38
troubleshooting, 9–2
CCM redundancy bus cable, 6–34, 7–2
Channel and control module. See CCM
Chassis. See IDU chassis
Checklist
installation tasks, 1–3
materials, 2–6
tools, 2–3
Commissioning
prerequisites, 2–7, 7–2
procedure, 7–3
Compass, 4–6
Components to be installed, 1–3
Concrete blocks (ballast), 3–10
arrangement on mount, 3–11