User's Manual
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Installation summary
- Ch 2 - Prerequisites
- Ch 3 - Installing mast mounts
- Ch 4 - Installing ODUs
- Ch 5 - Installing IFL cables
- Ch 6 - Indoor equipment
- Ch 7 - Commissioning HTs
- Ch 8 - Final steps
- Ch 9 - Troubleshooting
- Ch 10 - Maintenance
- App A - Acronyms
- App B - Standards compliance
- App C - Terminating IFL cables
- Index
1027145–0001 Revision E Installing indoor hub equipment 6–33Hub installation
Connect the IFL cable to the CCM:
1. Make sure power to the IDU is off (or disconnected).
A label on the CCM front panel advises:
CAUTION: POWER DOWN
ODU BEFORE CONNECTING
OR DISCONNECTING IF
Removing power from the IDU powers down the ODU.
Make sure the IDU is powered off before you connect or
disconnect the IFL cable.
2. Using a 90° adapter, connect the IFL to the CCM IFL
interface, as shown in figure 6-21.
Figure 6-21 Connecting the IFL cable
T0006041
CCM
IDU
IFL
interface
1
2
3
4
5
TM
BROADBAND
HUB CCM
N connector
90 adapter°
IFL
ENTERPREVNEXT
For each IDU to be installed, repeat all applicable steps
in sections 6.2 through 6.6 (pages 6–7 through 6–33).
6.6
Connecting the IFL
to the CCM