User's Manual
Table Of Contents
E. The phone's display will advise that it has found HH304 and ask you to confirm that you want to pair with it.
Confirm this.
F. Enter the passkey 1234, when your phone menu prompts you, and the phone will start to pair the headset.
G. Your phone screen will advise that pairing has been successful, and the blue LED on your headset will
change state, it will flash once every 3 sec. when Bluetooth pairing has been established.
If the pairing fails, the blue LED keep rapid flashing for about 2 minutes, then stop. A re-pairing procedure is
needed. Please refer to above A. ~ G.
NOTE: Your phone screen will also give the status. Once the headset and phone have successfully paired,
you are ready to place and receive calls.
Turning your headset ON and OFF
To switch your headset on, press the bigger button for about 3 seconds, the blue LED rapid flashing, release
the button. The headset power is turn ON. After 2 minutes, the LED will slow flash; indicate headset is
awaiting a call.
To switch your headset off, press and hold bigger button for 3 seconds until there are 5 times blue LED
flashing, release the button. You will find no LED indication.
Making a call with the headset by voice dialing
If your bluetooth phone supports voice dialing, you can use this feature with the headset. Please refer to your
phone's user guide for more information on voice control.
1. Voice dialing to your phone must be turned on and voice tags stored.
2. The headset power is ON.
3. Press the bigger button once on the headset.
4. A short tone will prompt you and you can speak the voice “tag” name as entered in the phone’s voice dial
phone book.
5. The phone automatically dials your selection, and you see the details of the call on the phone screen.
6. When connected, you are free to communicate normally by the headset.
NOTE: Make sure the headset and the cell phone are under link stage. For the examples of Ericsson and
Nokia cell phones, the
and symbols mean "link" status. For Nokia cell phone, it is necessary to press
the bigger button once to make the
symbols on the cell phone when the headset is out of 10 meters,
power off or after charging.
Last number redials from headset
Press the smaller button on the headset to redial the last number dialed.
Note: Your bluetooth phone must support handsfree profile.
Making a call from the mobile phone
1. Using the phone's keypad, dial the phone number.
2. To send the call, press the phone's SEND/CALL key the phone initiates the all.
3. The call will then transfer automatically to the headset when connection is made.
Ending a call from the headset
To end a call, press any button on headset.
Or you can end the call from the phone key pad.
Or when the other side hangs up the phone, the call ends automatically.
Receiving/Answering a call
If there is an incoming call, a ring tone will sound in your headset; just press any button on headset to answer
the call.
If your cell phone supports auto answering a call, the headset will take the incoming call and you don't need to
press any button.
Reject incoming call
Press the bigger button for 3 seconds on the headset to reject an incoming call.
Note: Your bluetooth phone must support handsfree profile.