User's Manual

Table Of Contents
Adjustable hook’s angle for your ear
You can use the adjustable hook to wear it more comfortable to your ear. Please see below.
Important: Please be careful when you are adjusting the hook’s angle. Do not force it too much which to avoid
it getting any damages happened.
Prepare to use your Bluetooth headset
1. Charging and battery time
Before use your headset, you need to fully charge the battery.
NOTE: When the headset is under charging, it stays on “OFF” mode. You’ll need to turn “ON” the headset to
use after the charging.
A. Connect the adaptor into an electrical outlet.
B. Plug the adaptor's connector into charging port.
C. While charging, the blue indicator light will stay solid on, when charging is completed, the light will be off.
Then you can take the adaptor's connector out from the headset and disconnect the adaptor from the
electrical outlet.
D. Charging time is about 2.5-3 hours. (Note: First time use, please charge at least 12 hours)
Note: The ear hook socket port and the power charging port is the same, it means you can either use
one port to insert the ear hook, while the other port to charging the battery.
2. Linking the headset to the phone (Pairing)
Before you use your headset for the first time, you must pair the headset to a Bluetooth phone. The Bluetooth
connection between the headset and your phone can be established by setting up a paired link. With a paired
link, the phone remembers the headset's ID, and process with future use.
3. Pairing the headset to the phone
Before you can pair your headset you need to put it into pairing mode.
Note: Pairing must be done every time while the headset establishes a link with a different Bluetooth phone.
Pairing mode can be entered by 2 methods:
One: When you charge the headset, the headset will automatically enter pairing mode. It will directly enter the
blow C. stage. Or
Two: Enter from the power OFF state. You will need to start from the below B. stage.
NOTE: During pairing, it is recommended that the headset and phone distance is as close as possible with no
solid objects in between.
To proceed pairing the headset with the bluetooth phone, please follow below stages:
A. Check the mobile phone user guide, and then find out the locations of Bluetooth device discovery.
B. Ensure headset is switched off.
C. Press and hold the bigger button for about 3 seconds, blue LED rapid flashing. This means the headset is
in pairing mode.
D. Perform a Bluetooth device discovery from the mobile phone. NOTE: It may take several seconds to
establish connections.