User's Manual

3. Pairing the headset to the audio gateway

Before you can pair your headset you need to put it into pairing mode.

Pairing mode can only be entered from the power OFF state of the headset. During pairing, it is

recommended that the headset and audio gateway distance is as close as possible with no solid objects in

between.

To proceed pairing the headset with the audio gateway, please follow this guide:

A. Ensure headset is switched off.

B. Press and hold the Talk button of headset for about 3 seconds, blue LED blinking 5 times, keep pressing,

then blue indicator and red indicator is cross blinking. This means the headset is in pairing mode.

C. Then using pair stick supplied; (In the opposite side of belt clip)

Press down on the pair switch on audio gateway for about 3 seconds until the blue LED blinking. Then

release.

D. After few seconds, audio gateway blue LED off, and headset blue LED light flash in standby mode (every

3 seconds).

E. The headset and audio gateway are now paired.

NOTE: Once the headset and audio gateway have successfully paired you are ready to place and receive

calls.

Turning your headset ON and OFF

To switch your headset on, press and hold Talk button for about 3 seconds, the blue LED lights 5 times,

release the button. The blue LED will be then blinking once every about 3 seconds. This is standby mode

which means the headset is awaiting a call.

To switch your headset off, press and hold Talk button for 3 seconds until there are 5 times red LED blinking,

release the button.

Note: The audio gateway is always on standby mode, while charging completed and disconnects the power

adaptor from the electrical outlet.

Connecting the audio gateway to your phone

The audio gateway needs to be connected to your phone. To enjoy wireless communication with headset:

1. Locate the headset socket on your phone.

2. Plug in the connector from audio gateway.

Note: There are lots of headset sockets on different mobile phones system. So, you may plug the audio

gateway connector directly to mobile phone as below right picture; or your mobile phone required an

adapter to make the connection as below right picture.

Fasten the cradle clip to audio gateway

Making a call from the mobile phone

The pairing stick