Owner's Manual

ManualsBrandsHuffy ManualsBicyclesHuffy Lights & Sounds Trike - SIDE button-Folding mechanism

Owner’s Manual

for Minnie

Lights & Sound

Trike

Please read and fully understand this

manual before operation.

Save this manual for future reference.

This manual contains important safety,

assembly, operation and maintenance

information.

H L&S Trike EN 092512 m0021

Summary of content (8 pages)

PAGE 1
Owner’s Manual for Minnie Lights & Sound Trike This manual contains important safety, assembly, operation and maintenance information. Please read and fully understand this manual before operation. Save this manual for future reference.
PAGE 2
An adult must fold and unfold the product each me Use only under adult supervision Read and follow the instruc ons in this manual completely The rider must always wear proper protec ve gear including a cpsc approved helmet while opera ng the product If you have a problem with this product please call Customer Service see Consumer Service contact info.
PAGE 3
• Always comply with local laws and regula ons. • For use on smooth paved surfaces only. • Understand all opera ng procedures before use. • Do not tow or pull any objects with the product. • Do not push or pull a child riding on the product. • Replace worn or broken parts immediately. • Handlebar hand grips and tube end plugs should be replaced if damaged, as bare tube ends have been known to cause injury.
PAGE 4
No. Descrip on No. Descrip on 1 Frame 13 Pedal, Le 2 Seat 14 Axle 3 Screw (x2) 15 Washer (x4) 4 Washer (x4) 16 Rear Wheel (x2) 5 Nut (x2) 17 Locking Cap 6 Fender 18 Plas c Bin 7 Fork 19 Screw 8 Front Wheel 20 Lock Bu on 9 Screw (x2) 21 Lights & Sound Unit 10 Washer (x2) 22 Screw (x2) 11 Nut (x2) 23 Cap Nut (x2) 12 Pedal, Right 24 Covers Assembly 1. Assemble Seat (2) to Frame (1) as shown in Assembly View 2.
PAGE 5
A 21 24 24 22 (supplied) 7 23 Lights & Sound (L&S) Assembly: Assembly hardware is located in the parts bag with the product. 1. Locate the L&S (21) on the Fork Stem (7) with control bu ons toward the rider. 2. Align the holes in the stem with those in the L&S. 3. Insert and ghten the Screws (22) and Cap Nuts (23) using the tool supplied. 4. Ensure hardware is secure so that it will not come loose. 5. Be careful not to over- ghten the hardware.
PAGE 6
C Thumb Button Opera on: Thumb Button • Push the bu ons with your thumbs to ac vate the L&S. • Repeat pushing the bu ons to cycle through the various light and sound features. If there are problems with opera on – ensure the ba eries are not low and they are properly installed. To reset the unit - remove the ba eries and re-install. WARNINGS: • Ba ery replacement is to be conducted by an adult. • Dispose of ba eries properly. Do not dispose of ba eries in fire, ba eries may explode or leak.
PAGE 7
Huffy Corporation Limited Warranty Part or model specifica ons are subject to change without no ce. This Limited Warranty is the only warranty for this product. There are no express warran es. The only uses for this product are described in this manual. Warranty registraon is not required. This limited warranty extends only to the original consumer and is not transferable. What does this Limited Warranty cover? This Limited Warranty covers all parts of the product.
PAGE 8
WARNING: ALWAYS WEAR YOUR HELMET WHEN RIDING THIS PRODUCT! CORRECT INCORRECT • • • • • Helmet should sit level on your head and low on your forehead Adjust the strap sliders below the ear on both sides. Buckle the chin strap. Adjust strap until it is snug. No more than two fingers should fit between the strap and your chin. A proper fitting helmet should be comfortable and not rock forward/backward or side to side.