User Manual

36
Tire and Tube Installation
A
B
1 2
3
STEPS (start opposite Filler Valve):
1. Squeeze de ated tire inwards and insert Tire Lever under Tire Bead
A
.
2. Hook end of Tire Lever on a Spoke
B
.
3. Insert second Tire Lever and slide along rim to remove tire bead.
4. Remove Inner Tube and Tire.
5. Inspect for cause of  at and remove any foreign object from the tire if necessary.
1. Using your hands, start with one Bead
A
of Tire
B
and install it all the way around Rim
C
.
2. Insert a slightly in ated Inner Tube
D
into the Tire
and make sure the Valve Stem
E
is straight and
aligned with the Rim Hole.
3. Work the second Tire Bead onto the Rim all the way
around. This will take a little more e ort than the
 rst Tire Bead did. Use Tire Lever Tools if needed.
4. Make sure the Tube does not get pinched
between Rim and Tire.
5. In ate Tire just enough that it takes shape.
6. Double check that both Tire Beads are seated
properly and that the Valve Stem is pointing
straight out.
7. Fully in ate tube to recommended pressure
listed on Tire side wall - do not over-in ate.
8. Install Valve Cap.
STEP 1  REMOVE EXISTING TIRE AND TUBE:
STEP 2  INSTALLING NEW TIRE AND TUBE:
D
A
B
C
E
A
Maintenance
5
WARNING - TO AVOID SERIOUS INJURY:
WARNING: ALWAYS WEAR YOUR HELMET
WHEN RIDING THIS PRODUCT!
• Helmet should sit level on your head and low on your forehead.
Exposed forehead can result in serious injury.
• Adjust the strap sliders below the ear on both sides.
• Buckle the chin strap. Adjust strap until it is snug.
• No more than two  ngers should  t between the strap and your
chin.
• A proper  tting helmet should be comfortable and not rock for-
ward/backward or side to side.
hearing, or control.
• Do not ride with both hands o the handlebar.
• Do not tow or push the product.
• Do not modify the product.
• Replace worn or broken parts immediately with original equipment.
• If anything does not operate properly, discontinue use.
• DO NOT TAMPER WITH THE ELECTRICAL SYSTEM: Doing so may create a short, causing
the fuse to trip or other damage including  re.
• Risk of Fire: Do not bypass fuse. Replace only with original size and type.
• The supply terminals are not to be short-circuited
• Non-rechargeable batteries are not to be recharged
• Batteries are to be inserted with the correct polarity
• Rechargeable batteries are only to be charged by adults.
• The battery chargers used with the toy are to be regularly examined for damage to the
cord, plug, enclosure and other parts, and in the event of such damage, they must not be
used until the damage has been repaired.
• Changes or modi cations to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• Do not use the vehicle in unsafe conditions such as snow, rain, loose dirt, mud sand or
 ne gravel. This may result in unexpected action such as tip over and skidding. Using the
vehicle in loose dirt, mud, sand, or  ne gravel may damage the electronics and gear box
inside the vehicle.
• Do not overload the vehicle. Do not drive in very hot weather, components may overheat.
Do not allow water or other liquids to come in contact with the battery or other electric
components.
Warnings and Safety