User Manual

4
WARNING - TO AVOID SERIOUS INJURY:
Failure of the rider to obey the following Safety Warnings can result in serious injury or
death. Check local laws governing the use of electrical vehicles.
• ADULT RIDERS ONLY.
• DO NOT USE THE VEHICLE IN AN UNSAFE MANNER OR AT AN UNSAFE SPEED. Not
intended for jumps - this can damage the product.
• CHOKING HAZARD: Small parts, adult assembly required.
• Before using this product, fully understand the controls and safety issues. Riders must
demonstrate the capability and skill to handle the vehicle and operate its controls to avoid
falls or collisions.
• Obey all tra c regulations, signs, and signals.
• Before each ride, check that the steering system is correctly adjusted and that all connec-
tion components are  rmly secured and not broken.
• While using the product, keep hands and  ngers away from wheels and other moving
parts to avoid danger of pinching or entrapment.
• Riders should always wear a properly  tted helmet that complies with U.S. Consumer
Product Safety Commission CPSC) Standard 16 CFR 1203 or equivalent standard for your
country.
• Always wear shoes. Gloves, knee and elbow pads recommended.
• Ride on the correct side of the road, in a single  le, and in a straight line.
• There are additional hazards of using the vehicle in areas other than private grounds.
• If possible, avoid riding at night, dusk, dawn and any other time of poor visibility.
• IF YOU MUST RIDE AT NIGHT OR AT TIME OF POOR VISIBILITY:
• Use a correctly installed headlight and taillight.
• Headlights are required by all states for nighttime riding and taillights are required in
some states.
• Battery-powered lights or  ashing safety lights are also recommended.
• MAKE YOURSELF MORE VISIBLE TO MOTORISTS.
• Re ectors: For your own safety, do not ride the bicycle if the re ectors are incorrectly
installed, damaged, or missing. Make sure the front and rear re ectors are vertical. Do
not allow the visibility of the re ectors to be blocked by clothing or other articles. Clean
the re ectors, as necessary, with soap and a damp cloth.
• Wear light-colored or re ective clothing, such as a re ective vest and re ective bands for
your arms and legs.
• Use re ective tape on your helmet.
• USE EXTRA CAUTION IN WET WEATHER:
• Ride slowly on damp surfaces because the tires will slide more easily.
• Allow increased braking distance in wet weather.
• AVOID HAZARDS TO PREVENT LOSS OF CONTROL OR DAMAGE TO YOUR WHEELS:
• Be aware of drain grates, soft road edges, gravel or sand, pot holes or ruts, wet leaves, or
uneven paving.
• Cross railroad tracks at a right angle to prevent the loss of control.
• Do not carry any passengers.
• Do not carry any items or attach anything to your bicycle that could hinder your vision,
Warnings and Safety
37
Troubleshooting
Symptoms Possible Cause Solution
Display is on, motor does
not work or works slowly/
intermittently
Battery voltage is low Charge Battery
Battery is loose in compart-
ment
Re-seat Battery
Wire Harness connectors
loose
Check that Harness connec-
tors are  rmly attached.
Reduced ride time
Battery is low Recharge
Battery does not hold a
charge
Replace Battery
Battery does not fully charge
Battery at end of life. Replace Battery
Charger not connected cor-
rectly
Re-check charger connec-
tions at battery and wall
socket
Battery not fully seated Re-seat Battery
Display does not turn on
Wire Harness connectors
loose
Check that Harness connec-
tors are  rmly attached.
Display bad Replace Display
Power is o Turn Power on
No Pedal assist
Wire Harness connectors
loose
Check that Drive Motor Har-
ness connectors are  rmly
attached.
Motor bad Replace Motor
Speed sensor magnet not
aligned
Align magnet on wheel with
sensor on frame near motor
Troubleshooting