User Manual

28
e-Bikes Maintenance:
GENERAL: The vehicle should be checked for damage, missing or badly worn parts before
each use. If any part of the product does not operate properly – discontinue use.
• Check the tightness of the fasteners before each use. Replace any fasteners that are damaged.
• Inspect the product frequently. Failure to inspect the product and to make repairs or
adjustments, as necessary, can result in injury to the rider or to others. Make sure all parts are
correctly assembled and adjusted as written in this manual and any “Special Instructions”.
• Immediately replace any damaged, missing, or badly worn parts.
• Make sure all fasteners are correctly tightened as written in this manual and any “Special
Instructions”. Parts that are not tight enough can be lost or operate poorly. Over tightened
parts can be damaged. Make sure any replacement fasteners are the correct size and type.
• Check the tightness of the wheels.
• Keep the product clean and free of dirt, dust and water. This will prolong the useful life of the
product.
• Always remove the battery when replacing a component or performing maintenance.
• Periodically check your e-Bike’s wiring and motor condition and mounting.
• Always store your e-Bike indoors. Bike’s left outside in weather can deteriorate very quickly.
Store your e-Bike in a clean dry environment. Do not cover with plastic which will hold mois-
ture inside and a ect your bike’s electrical system.
• Store your battery indoors during cold weather to optimize battery performance.
CAUTION: Self-locking nuts and other self-locking devices may lose their e ectiveness
when re-used.
CLEANING: Do not submerge the drive unit in water or wash with a pressurized hose. Keep
all components clean, especially the battery pack contact points. Clean carefully with soft, damp
cloth using only mild soap and water.
STORAGE: Always store the battery pack in a cool dry place. Keep it away from sources of
heat, such as stoves and heaters.
During periods of prolonged storage, battery pack should be
charged at leased once every 6 months at a minimum of 60% or every 3 months at 40%. Do
not charge higher than 60% when storing.
NOTE: If the instructions in this manual or any “Special Instructions” are not su cient for
you, please contact customer service.
Maintenance
13
Assembly
Installing Front Light
Handlebar Installation
2/4 BOLT STEM:
1. If necessary, loosen the Handlebar
Clamp Bolt(s)
A
and rotate Handle-
bar
B
into a comfortable riding
position.
2. Tighten Handlebar Clamp Bolts(s)
A
securely.
NOTE: On four bolt stems, tighten Bolts
A
evenly in a cross-pattern as shown.
Do not over tighten.
WARNING: If the handlebar
clamp in not tight enough, the
handlebar can slip in the stem. This
can cause damage to the handlebar or
stem, and can cause loss of control.
NOTE: (various models)
1. Position FRONT Re ector
C
so it points straight forward.
2. Tighten Clamp Screw.
Testing Stem and Handlebar Tightness
3 1
2 4
A
B
C
With Light facing forward and against
Fork Support

:
1. Insert Bolt and Washer
B
through
Light Bracket
C
and Fork Support

.
2. Install Locknut
D
fully and
securely so Light does not move.
IMPORTANT! Make sure
Light is upright and facing forward.
D
A
C
B