User Manual
Table Of Contents
- Product name and Model
- Specifications
- Appearance and Size
- Function and Button Definition
- Install Instructions
- General Operation
- General Settings
- ◆Trip Distance Clearance
- ◆Unit Mile/KM toggling
- ◆Wheel Diameter Settings
- ◆Speed limit Settings
- ◆Battery Power bar Settings
- ◆Assist Level Settings
- ◆Controller Over-current Cut Settings
- ◆Power assist Sensor Settings
- ◆Speed Sensor Settings
- ◆Slow Start up Settings
- ◆Backlight Brightness Settings
- ◆Power-on Password Settings
- Power-on Password Enable/Disable
- Power-on Password Change
- ◆Exit settings
- Recover default settings
- Quality assurance and warranty scope:
- Warnings:
- Attached list 1: Error code definition
- Attached list 2：Assist level ratio defaults
6
◆Speed limit Settings
Set LS represents speed limit settings. When current speed is faster than speed limit,
the E-bike system will be switched off automatically. Limited speed range is 12Km/h to
40Km/h. The default value is 25Km/h.
To change basic settings, press UP/DOWN to increase or decrease until the desired
value is displayed.
To store a changed setting, press ON/OFF button and
the screen says 'OK' then
returns to G
eneral settings interface
.
Speed Limit Settings Interface
◆Battery Power bar Settings
Set Voltage represents voltage settings. Each bar represents a voltage value. 5 bar-
voltage values must be entered one by one.
For example, Vol-1 is the first bar
voltage and the default value is 31.5V. Press
UP/DOWN to increase or decrease the voltage value.
To store a changed setting, press the ON/OFF button and access the second bar
setting.
After 5 bar-voltage values are entered, press ON/OFF button to confirm. T
he
screen says 'OK' and then returns to G
eneral settings interface
.
Battery Power Bar Settings
Personalized Parameter Settings(Specific Set)
Personalized Parameter Settings(Specific Set) can meet various riders’
requirements.
Hold both UP and DOWN button for 2s to enter General Settings and hold the UP
and DOWN button for 2s again to enter Personalized Parameter Settings selection
interface. Press the UP or DOWN button to choose the settings items, then press the
ON/OFF button to enter the corresponding settings interface.