Instructions/Assembly Guide

Tire and Tube Installation

1 2

STEPS (start opposite Filler Valve):

1. Squeeze de ated tire inwards and insert Tire Lever under Tire Bead

2. Hook end of Tire Lever on a Spoke

3. Insert second Tire Lever and slide along rim to remove tire bead.

4. Remove Inner Tube and Tire.

5. Inspect for cause of  at and remove any foreign object from the tire if necessary.

1. Using your hands, start with one Bead

of Tire

and install it all the way around Rim

2. Insert a slightly in ated Inner Tube

into the Tire

and make sure the Valve Stem

is straight and

aligned with the Rim Hole.

3. Work the second Tire Bead onto the Rim all the way

around. This will take a little more e ort than the

 rst Tire Bead did. Use Tire Lever Tools if needed.

4. Make sure the Tube does not get pinched

between Rim and Tire.

5. In ate Tire just enough that it takes shape.

6. Double check that both Tire Beads are seated

properly and that the Valve Stem is pointing

straight out.

7. Fully in ate tube to recommended pressure

listed on Tire side wall - do not over-in ate.

8. Install Valve Cap.

STEP 1  REMOVE EXISTING TIRE AND TUBE:

STEP 2  INSTALLING NEW TIRE AND TUBE:

Maintenance