Instructions/Assembly Guide

Charging the Drive Battery:

WARNINGS:

• All large Li-Ion batteries are a potential  re

risk and should be charged in a safe place,

preferably outside or in the middle of a

garage  oor.

• Never charge a lithium battery unsuper-

vised inside a house or building.

• Only an adult who has read and under-

stands the safety warnings should handle,

charge or recharge of the battery.

• See other Battery Warnings in this manual.

• Check the drive battery and charger (sup-

ply cord, connector) for wear and damage

before charging. Do not charge the battery

if damage has occurred. Only replace with

the same type and voltage rechargeable

battery and charger supplied by the manu-

facturer.

• Only use the rechargeable battery (or

equivalent replacement) and charger supplied with your vehicle.

• The drive battery should be charged when depleted, or if not used regularly, once a month.

Failure to charge the battery as directed will cause permanent damage to the battery and

will void the warranty.

• Charge only when battery has cooled to room temperature after a ride.

STEPS:

IMPORTANT!

Before using the unit for the  rst time fully charge the Battery.

Battery Charger will shut o when Battery is fully charged, but never charge

longer than 12 hours.

NOTE: Your e-Bike Li-Ion Battery can be charged either installed in the bike or

removed.

1. Turn power switch OFF.

2. Open Charging Port

3. Plug Charger plug into unit Charging Port

4. Plug Charger into Wall outlet.

5. When battery is fully charged, un-plug

charger from the wall outlet and disconnect

from charger port.

NOTES:

• The charger may feel warm during the

charging. If excessively hot, unplug and

replace.

• This product has charging protection: When

charging, all functions are turned OFF.

• Battery Charge Level and ON/OFF Switch

Operation