Instructions/Assembly Guide

IMPORTANT! Before using the unit for the  rst time fully charge the Battery.

Battery Charger will shut o when Battery is fully charged, but never charge

longer than 12 hours.

NOTE: Your e-Bike Li-Ion Battery can be charged either installed in the bike or

removed.

Operation

Charging the Drive Battery:

WARNINGS:

• All large Li-Ion batteries are a potential re risk and should be charged in a safe place,

preferably outside or in the middle of a garage oor.

• Never charge a lithium battery unsupervised inside a house or building.

• Only an adult who has read and understands the safety warnings should handle, charge

or recharge of the battery.

• See other Battery Warnings in this manual.

• Check the drive battery and charger (supply cord, connector) for wear and damage

before charging. Do not charge the battery if damage has occurred. Only replace

with the same type and voltage rechargeable battery and charger supplied by the

manufacturer.

• Only use the rechargeable battery (or equivalent replacement) and charger supplied

with your vehicle.

• The drive battery should be charged when depleted, or if not used regularly, once a

month. Failure to charge the battery as directed will cause permanent damage to the

battery and will void the warranty.

• Charge only when battery has cooled to

room temperature after a ride.

STEPS:

1. Turn power switch OFF

2. Open Charging Port

and plug in

Charger.

3. Plug Charger into Wall outlet.

4. When battery is fully charged, un-

plug charger from the wall outlet and

disconnect from charger port. - Close

charging port cover.

NOTES:

• The charger may feel warm during the

charging. If excessively hot, unplug and

replace.

• This product has charging protection: When charging, all functions are turned OFF.

• Battery Charge Level