Instructions/Assembly Guide

11
Installing the Front Wheel (light and fender optional)
A
E
F
C
D
I
I
B
G
H
WARNINGS:
• Do NOT use Axle Nuts
G
without serrations to
attach the front wheel.
• Failure to obey these steps can allow the front wheel
to loosen while riding. This can cause injury to the
rider or to others.
NOTE: If any hardware is already
attached, remove and set
aside.
MOUNTING FENDER:
1. Insert Fender
A
up
into Fork as shown.
2. Install Front Light
and Mounting Bolt
C
through Fork
and Fender Tab
B
.
3. Install Nut
D
securely.
MOUNTING WHEEL:
4. Set the wheel into
the Front Fork
B
making sure the
Disc Brake
E
 ts up
into the Disc Brake
Caliper
F
.
5. Install Wheel
Retainers
H
making sure Wheel
Retainer tabs are in
the fork tab holes as shown.
6. Install Axle Nuts
G
with serrated surface facing IN.
7. With the wheel in the center of the fork, tighten both Axle Nuts securely. Ensure wheel
spins freely without contacting fork or fender.
MOUNT FENDER BRACES:
Move Fender Braces so that lower mounting holes line up
I
and install one bolt on each
brace securely - NOTE: Upper or lower location.
Assembly