User Manual

P08 Speed limit. Range: 0-50km/h, 50 means without limit
No-Communication Status (controlled by the meter): when the real speed is over the ones we set, the meter would shut off
PWM output; when less than the speed we set, the meter would turn on PWM output automatically, the driving speed would be
±1km/h; (Speed limit is for PAS, not for Throttle)
Communication Status (controlled by the controller): The driving speed keeps same with the ones we set. Random error:
±1km/h. (Speed limit is for both PAS and Throttle)
Notes: These data are based on KM. When changing KM to Mile, the speed value on the screen would convert to correct Miles
automatically, but if you do not change the setting of speed limit from KM to Mile, it would be different from the real speed limit in
Mile.
P09 Zero start & Non-zero Start. 0 is Zero Start, 1 is Non-zero Start
P10 Driving mode.
0: driven by PAS. Throttle is useless at this time.
1: driven by Throttle. PAS is useless at this time.
2: driven by PAS & Throttle. Throttle is useless at Zero Start status.
P11 PAS sensitivity. Range: 1-24
P12 PAS start strength. Range: 0-5
P13 PAS magnet type: 5, 8, and 12.
P14 The Current-limiting of Controller. default is 12A. Range:1-20A
P15 Unspecified
P16 Reset ODO. Long press for 5s, ODO could be reset.
P17: (Customer Designated) Auto Cruise Option.
0: No Auto-cruise
1: Auto-Cruise On. Trigger time of auto-cruise is decided by the controller.
P18: (K5S, APT Protocol Bound) Throttle Level Option.
0: No throttle level. 1: Has throttle levels.
P19: (K5S Protocol Bound) 6km/h Cruise Throttle Definition.
0: Throttle has no 6km/h cruise definition. 1: Throttle has 6km/h cruise definition.
Note: Due to product upgrade, the product you purchased may be
slightly different from the descriptions in this user manual, and this
won’t affect normal usage.