User Manual
Table Of Contents
- Product name and Model
- Specifications
- Appearance and Size
- Function and Button Definition
- Install Instructions
- General Operation
- General Settings
- ◆Trip Distance Clearance
- ◆Unit Mile/KM toggling
- ◆Wheel Diameter Settings
- ◆Speed limit Settings
- ◆Battery Power bar Settings
- ◆Assist Level Settings
- ◆Controller Over-current Cut Settings
- ◆Power assist Sensor Settings
- ◆Speed Sensor Settings
- ◆Slow Start up Settings
- ◆Backlight Brightness Settings
- ◆Power-on Password Settings
- Power-on Password Enable/Disable
- Power-on Password Change
- ◆Exit settings
- Recover default settings
- Quality assurance and warranty scope:
- Warnings:
- Attached list 1: Error code definition
- Attached list 2：Assist level ratio defaults
8
◆Controller Over-current Cut Settings
Current Set represents controller over-current cut settings. The current value can be
changed from 7.0A to 25.0A.
To change basic settings, press the “+” or the “-” button to increase or decrease the
value of the current.
To store a changed setting, press the “ON/OFF” button. The screen says “OK” and
returns to previous menu.
Current Settings Interface
◆Power assist Sensor Settings
‘Assistant num’ represents the numbers of magnets on PAS disk. The default
number is 12. The adjustable range is 5 to 24.
To change the number of magnets on PAS disk, press “UP” or “DOWN” button to
choose the desired quantity.
To store a changed setting, press the “ON/OFF” button. The screen says “OK” and
returns to previous menu.
The PAS Magnet Quantity Settings
◆
Speed Sensor Settings
S‘Speed Sensor’ represents speed sensor settings. The default value is 1.
To change speed sensor settings, press the “UP” or the “DOWN” button to select the
quantity of magnets on the bike spokes (the range is from 1 to 15).
To store a changed setting, press the “ON/OFF” button. The screen says “OK” and
returns to previous menu.