Owner's Manual

14
Seat Installation
Attach Seat to Seat Post (fi g 09):
(pre-assembled on some models)
• Loosen nuts on Seat Clamp (A)
and rotate Seat (14) into riding
position.
• Put the Seat Post (33) fully
through the Seat Clamp.
• Tighten the Seat Clamp so the
Seat stays on the seat post.
• If the Seat Clamp has a nut on
each side, tighten both nuts
equally.
g 09
A
33
14
CAUTION: If you accidentally drop the seat post into the seat tube, it
may be diffi cult to remove it.
• Point the Seat forward and put the
Seat Post into the Seat Tube (B)
(fi gs 10, 11).
WARNING: To prevent the seat
coming loose and possible loss of
control, the “MIN-IN” (minimum inser-
tion) mark (C) on the seat post must
be below the top of the Seat Tube.
g 10
14
C
B
33
B
C
Tighten the quick release lever (fi g 11):
• Move the Quick Release Lever (D)
to the “open” position so the word
“open” is pointing away from the
Seat Post Clamp (E).
NOTE: The words “open” and “close”
are on opposite sides of the quick
release lever.
g 11
E
B
F
33
D