Owner's Manual

12
Handlebar and Stem Installation
WARNING: To prevent steering system damage and possible loss of
control, the “MIN-IN” (minimum insertion) mark (A) on the stem must be below
the top of the Locknut (B).
NOTE: Remove plastic Cap (E) from
the end of the Stem (13).
1. Insert the Stem into the fork (fi g
07).
2. Point the Stem towards the front
of the bike.
3. Tighten the Stem Bolt (C) just
enough to hold it in position.
4. If necessary, loosen the Handle-
bar Clamp Nut (D) and rotate
Handlebar (12) into a comfortable
riding position (fi g 08).
5. Tighten Handlebar Clamp Nut just
enough to hold it in position (fi g
08).
6. Align the Stem with the front tire
and tighten the Stem Bolt securely
(fi g 07).
WARNING: Do not over tighten
the stem bolt. Over tightening the stem
bolt can damage the steering system
and cause loss of control.
g 07
C
13
A
A
B
E
B
7. If necessary, re-adjust Handlebar.
8. Tighten Clamp Nut.
g 08
D
12
WARNING: If the handlebar clamp in not tight enough, the handlebar
can slip in the stem. This can cause damage to the handlebar or stem, and can
cause loss of control.