Owner's Manual

9
Front Fender Installation
Use Screw Driver and Wrench:
1. Front fender attaching hardware
has been pre-assembled onto the
fork. Remove the Bolt (8) and
Washer (9) and Nut (10) from the
fork crown.
2. Remove lower mounting Bolts (7)
and Washers (6) from the dropout
before starting (fi g 01).
g 01
7
6
8
9
10
Model with Front Refl ector (45):
(not included on all models)
3. Place the Fender (3) in the fork
with the longer fork mounting tab
(A) on the rear side of the fork (fi g
02).
4. Place Refl ector (45) between fork
and Front Fender Tab (D).
5. Insert the Bolt (46) through the
Washer (9), Fender Tabs (A,D)
and fork mounting hole.
6. Install Washer (9) and Nut (10)
onto Bolt (46) and tighten se-
curely.
7. Make sure Refl ector (45) is point-
ing forward.
g 02a
46
45
9
A
D
10
9
3
continued >>