Owner's Manual

Testing Seat Clamp and Post Clamp Tightness

To test the tightness of the seat clamp and the post clamp:

WARNING: Every time the quick release mechanism is loosened, make sure

the red reﬂ ector is correctly positioned.

• Try to turn the seat side-to-side and to move the front of the seat up and down.

• If the seat moves in the Seat

Clamp (A):

• Loosen the Seat Clamp (A).

• Put the seat in the correct position

and tighten the Seat Clamp tighter

than before.

• Do this test again, until the seat does

not move in the Seat Clamp.

g 09

• If the Seat Post (A) moves in the Seat Tube (B):

• Move the Quick Release Lever to the “open” position OR loosen the Clamp Bolt

and Nut (C).

• Put the seat in the correct position and tighten the Quick Release Lever tighter

than before OR tighten the Clamp Bolt and Nut tighter than before.

• If necessary, loosen Quick Release Lever, tighten Adjusting Nut (D) and re-tight-

en Quick Release Lever.

• Do this test again, until the seat post does not move in the seat tube.

Assembly