Owner's Manual

11
• Bicycle Assembly
Handlebar and Stem Installation - continued
Four Bolt Clamp Top Mount:
• If necessary, re-adjust Handlebar.
• Tighten Clamp Screws (D) evenly ac-
cording to pattern.
NOTE: Do not over tighten. Torque to 17
ft-lbs.
3 1
2 4
D
28
g 08
Four Bolt Clamp, Front Mount:
• If necessary, re-adjust Handlebar.
• Tighten Clamp Screws (D).
NOTE: Do not over tighten. Torque to 17
ft-lbs.
g 08b
3 1
2 4
28
D
Two Bolt Stem:
• Loosen Clamp Screws (A).
• Re-adjust Handlebar (B) to a comfort-
able riding position.
• Tighten Clamp Screws (A).
NOTE: Do not over tighten. Torque to 17
ft-lbs.
A
B
WARNINGS:
• Do not over tighten the stem bolt. Over tightening the stem bolt can damage the
steering system and cause loss of control.
• If the handlebar clamp in not tight enough, the handlebar can slip in the stem.
This can cause damage to the handlebar or stem, and can cause loss of control.
Assembly