Instructions / Assembly

10
Assembly
WARNING: To prevent the Seat coming
loose and possible loss of control, the “MIN-IN”
(minimum insertion) mark
A
on the Seat Post must
be BELOW the top of the Seat Tube
B
.
STEP 1 INSERT SEAT POST INTO SEAT TUBE:
• If needed, loosen Seat Post Clamp Screw
D
or
open the Quick Release Lever
E
.
• Point the Seat forward and put the Seat Post
C
into the Seat Tube
B
with the “MIN-IN” marks
BELOW the top of the Seat Tube as shown.
STEP 2  BOLT SEAT CLAMP: (various models)
• With Seat Post
C
inserted according to STEP 1 - Tighten
Screw
D
securely so Seat supports the rider without mov-
ing.
STEP 3  QUICK RELEASE LEVER: (various models)
CAUTION: Operate the Quick Release Lever by HAND ONLY
 DO NOT USE TOOLS.
1. As needed, open and close the Quick Release Le-
ver
E
with one hand and tighten or loosen the
Adjusting Nut
G
by hand, so that you  rst feel
resistance to the Quick Release Lever when it is in
the “OPEN” position
1
.
2. Push the Quick Release Lever to the “CLOSE”
position
2
- It will take strong force to clamp se-
curely so that the Quick Release Lever lays against
the Seat Post Clamp
F
.
WARNING: You must use strong force
to move the Quick Release Lever securely to the
“CLOSE” position
2
. This ensures that the seat
does not move during normal operation.
REFLECTOR: (as equipped)
Position Seat Post Re ector (if equipped)
H
so it points straight
backwards. Tighten Clamp Screw.
Seat Installation
A
A
D
G
1
2
3
1
2
C
B
C
F
C
E
H
7
Assembling the Wheels
NOTE:
• The front and rear wheels attach
the same way, with safety
washers.
1. If the Axle Nuts

are already
attached to the wheel axle

,
begin by removing them with an
open end or adjustable wrench.
2. Set the wheel into the Wheel
Dropouts

.
3. Install Wheel Retainers

making sure the tabs are in the
Dropout tab holes

.
4. Attach the wheel with the Axle
Nuts

.
5. Make sure the wheel is in the
center of the fork/frame and
tighten Axle Nuts securely.
WARNING:
• Ensure wheel spins freely without contacting the frame or fork.
• Failure to obey these steps can allow the wheel to loosen while riding. This can cause
injury to the rider or to others.
A
B
C
D
E
Assembly