Instructions / Assembly

6
Parts List
Parts List
#
Description: # Description:
1 Frame 8 Seat Clamp Hardware
2 Fork 9 Wheel Assembly (x2)
3 Handlebar 10 Tire
4 Grips (x2) 11 Tube
5 Handlebar Stem 12 Safety Washer (x4)
6 Headset Bushings (x2) 13 Front Axle Nuts (x2)
7 Seat/Post 14 Rear ‘Acorn’ Axle Nuts (x2)
3
4
5
7
6
1
8
2
12
12
13
14
9 10 11
9 10 11
11
Assembly
Testing Seat Clamp and Post Clamp Tightness
To test the tightness of the seat clamp and the post clamp:
•
Try to turn the seat side-to-side and to move the front of the seat up and down.
• If the seat moves in the Seat Clamp:
• Loosen the Seat Clamp Nut.
• Put the seat in the correct position and tighten the Seat Clamp tighter than before.
• Do this test again, until the seat does not move in the Seat Clamp.
• If the Seat Post moves in the Seat Tube Clamp:
• Loosen the Seat Clamp Lever.
• Put the Seat Post in the correct position and tighten the Seat Clamp Nut tighter than
before.
• If necessary, tighten or loosen Hand Nut so that Quick Release tightens securely.
• Do this test again, until the Seat Post does not move in the Seat Tube Clamp.
Seat Bolt Saddle Adjustment (various models)
SINGLE BOLT CLAMP:
1.
Loosen the Clamp Bolt
A
su ciently to
allow any Serrations
B
on the mechanism to
disengage before changing the saddle’s angle.
2. With serrations fully re-engaged and saddle in a
comfortable riding position, tighten the Clamp
Bolt
A
securely to ensure the saddle will not
come loose.
WARNING: Serrations on the mating
surfaces of the Clamp can wear with use and
adjustment. Check that the Clamp is tight and
secure before each ride.
DUAL CLAMP:
3. Loosen Clamp Bolt/Nut
C
as needed and adjust Seat to a comfortable riding position.
4. With Clamp fully on Seat Post as shown, tighten Bolt/Nut
C
securely so that seat does
not move when in use.
Seat Bolt Mount (various models)
Some models have a Bolt
I
, Washer
J
and
Nut
K
instead of a Quick Release Lever.
• If needed, loosen the nut enough to insert
the Seat Post
E
.
• Point the seat forward and insert Seat Post
to the Minimum Insertion marks
B
.
• Tighten Nut securely so it supports the rider
without moving.
A
C
B
B
J
C
K
E
I