Owner's Manual

NOTE: Turn unit upside down before installing Wheel Assembly.

Steps: (see image on page 14)

1. Place a Wheel Bushing (25) in each fork end as shown next page.

2. Make sure Right Crank is on the Right side of the unit.

3. Place Wheel (30) so that both Bearings (A) set in the Wheel Bushings.

4. Make sure Wheel Spacers (B) are centered in the Fork.

5. Place a Wheel Bushing on top of the Axle as shown, on both sides.

6. Place a Wheel Retainer (24) on each fork end as shown.

7. Install 2 Bolts (26) and Washers (27) through fork ends and Wheel Retainers.

8. Install Washers (27) and Nuts (28) as shown.

9. Tighen 4 Nuts securely and evenly. Make sure Wheel spins freely.

WARNING: Ensure the front wheel is installed correctly so that when pedaled

the unit moves forward. The wheel is correctly installed when the right crank arm is

on the right side (from rider position).

Front Wheel Installation

Loosen the Front Brakes:

1. Squeeze the two Brake arms together

(A).

2. Lift out the Brake Cable Guide (B) from

the Guide Bracket (C).

This will allow the tire to ﬁ t between the

brake pads.

• Assembly