User Manual

8
Attaching Tilt Guards:
STEPS:
NOTE:
Turn unit up-side down before starting.
1. Rotate each Tilt Guard
A
BACKWARDS as shown so that rear Screw holes line up.
2. Install Two Screws
B
through Tilt Guards and into Body.
3. Tighten securely - Do not over-tighten: This can strip out the screws which may come
loose.
Assembly
A
B
13
BA
C
E
D
Replace Drive Battery:
Maintenance
STEPS:
NOTE:
Turn unit up-side down before
starting.
1. Fully unZip plush Cover
A
.
2. Remove Screw and Open Battery
Compartment
B
.
3. Pull out Battery
C
far enough to
disconnect the Red and Black
D
Battery Terminals.
4. Place the old battery in a plastic bag.
5. Install a replacement battery (same as
original equipment)
6. Reconnect the Battery Terminals - Red
to Red, Black to Black.
7. Reinstall Battery Compartment Cover
and Screw
B
.
8. Reinstall plush Cover Zipper
A
.
9. Wipe the battery with a dry cloth prior
to storage. Wash cloth separately from
other clothes.