User Manual

14
Assembly
Assembly
STEPS:
1. Remove Hardware
from Front Axles
A
.
and
B
- set aside.
2. Insert Rear Axle
B
through Rear Motor
Housing
C
.
FRONT WHEELS:
1. Install Front Wheels
D
into both sides of the
front axle.
2. Install one Washer
and Locknut
E
on
each Axle and tighten
securely.
3. SNAP Wheel Covers
F
into position.
B
C
A
D
E
F
GH
I
F
REAR WHEELS:
1. Install Both Rear Wheels
H
onto Axle so that
Drive Collar
G
 ts inside
Drive Motor.
2. Install Washers and
Locknuts
I
fully and
securely on both ends of
rear Axle.
3. SNAP both Wheel Covers
F
 rmly into place.
15
Assembly and Battery Connect
STEPS:
1. If installed, remove Seat Screw and Seat
A
.
2. Ensure that Power Connector
B
Is  rmly connected to
Slot
C
.
3. Press Seat
A
 rmly into the corresponding position
on the car body, make sure the two Tabs on the rear
of the seat press into the corresponding holes on
the car body.
4. Install Seat Screw
A
securely. Do not over
tighten.
A
C
B
Assembly