User Manual

18
Maintenance
Maintenance Repair and Service
GENERAL: The vehicle should be checked
for damage, missing or badly worn parts
before each use. If any part of the product
does not operate properly – discontinue use.
• Check the tightness of the fasteners before
each use. Replace any fasteners that are dam-
aged.
• Inspect the product frequently. Failure to in-
spect the product and to make repairs or ad-
justments, as necessary, can result in injury to
the rider or to others. Make sure all parts are
correctly assembled and adjusted as written
in this manual and any “Special Instructions”.
• Immediately replace any damaged, missing,
or badly worn parts.
• Make sure all fasteners are correctly tightened
as written in this manual and any “Special
Instructions”. Parts that are not tight enough
can be lost or operate poorly. Over tight-
ened parts can be damaged. Make sure any
replacement fasteners are the correct size and
type.
• Check the tightness of the wheels:
NOTE: If the drive wheel is not tight, it will not
engage the gears and the vehicle will not run.
• Ensure the battery bracket is securely in place
before use.
• Store the vehicle indoors. Keep it away from
sources of heat, such as stoves and heaters.
• Keep the product clean and free of dirt, dust
and water. This will prolong the useful life of
the product.
• Clean the vehicle with a soft, dry cloth. To
restore shine to plastic parts, use a non-wax
furniture polish. Do not use automotive wax,
abrasive cleaners or wash the vehicle with
soap and water.
NOTE: If the instructions in this manual or
any “Special Instructions” are not su cient
for you, please contact customer service.
CAUTION: Self-locking nuts and other self-
locking devices may lose their e ectiveness
when re-used.
Batter
y
Stora
g
e and Dis
p
osal
11
Assembly
NOTE:
With Suspension Rod
B
pushed fully DOWN, Push Lock Lever
C
fully so
Suspension Rod is LOCKED in place. Pull up gently to check - it should not pull lose.
A
A
B
B
C
C
1. Rotate
A
(the front wheel pivot assembly) upward about 50 degrees.
2. Rotate the front suspension components forward as shown.
3. Put the front wheel pivot assembly
A
down as shown.
Assembly
BEFORE STARTING:
• Cut Zip-Tie holding down Frame.
• Remove Packing from bottom of Frame Channel.