Owner’s Manual 36v Battery Ride-On Motorcycle © Copyright Huffy Corporation 2022 H-e-MC 05-09-22 m0960 EN Date Code Label Here EN *styles and color may vary This manual contains important safety, assembly, operation and maintenance information. Please read and fully understand this manual before operation. Save this manual for future reference. Always wear approved helmet and safety equipment when using this product.
Manual Index Safety and Warnings.....................................................................................................2-5 Parts List..................................................................................................................................6-7 Assembly................................................................................................................................8-13 Operation.................................................................................
All of these safety rules and guidelines must be followed or serious injury or death may occur to the user. Keep this product away from small children. • Adult assembly required. Choking hazard to children under the age of 3 years - contains small parts. Keep small children away when assembling. • To reduce the risk of injury, adult supervision is required.
Warnings and Safety WARNINGS - continued demonstrate the capability and skill to handle the vehicle and operate its controls to avoid falls or collisions. It is the responsibility of the adult to educate the child and determine if they are capable of operating the vehicle safely and that safe practices are used when using the vehicle.
The following safety hazards may result in serious injury or death to the user of the vehicle: • Battery Charger for Indoor use only. Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire or explosion. Only use the supplied rechargeable battery (or lead-acid or lithium suitable replacement) and charger with the vehicle. • Using the rechargeable battery and charger for any other product may result in overheating, fire or explosion.
NOTE: Some parts shown are assembled on both sides.
# Description # Description 1 2 Vehicle Body 9 Bolt (x5) Mudguard/Fender 10 Screw (x6) 3 Head Cover 11 Washer (x4) 4 Wheel - Front 12 Lithium Battery 5 Fork 13 Instruction manual 6 Foot Rest (pair) 14 Battery Charger 7 Front Axle 15 Allen Wrench 8 Nut (x4) Parts Assembly Parts Assembly 7
Assembly Introduction to Assembly This Owner’s Manual may be made for several different style products. • Some illustrations may vary slightly from the actual product. • Follow instructions completely. • If the product has any parts that are not described in this manual, look for separate “Special Instructions” that are supplied with the unit. • All features, components and accessories are not included on all models. • Use the Index page to locate specific sections of this manual.
Torque Table - Recommended Torque: owner’s manual) on each component as it is tightened. NOTE: Please check that all fasteners on the product are torqued according to the table below: Recommended RecommendedTorque Torquefor forclean, clean,dry drythreads: threads: FastenerSize Size Fastener Torque Torque(ft-lb (ft-lb/ /N•m) N•m) .157inin(6(4mm) mm) .236 3.1 ft-lbs N•m) 7-11.1 ft-lb(4.2 (9.5-15 N•m) .196inin(8(5mm) mm) .314 5 ft-lbs (6.8(23-25 N•m) N•m) 17-18.5 ft-lbs .236inin(10 (6 mm) .
Assembly B Assembly C A D F B E STEPS: 1. Position the fork against the neck frame as shown. 2. Put washer and locknut fully on Bolt and insert down through fork and neck assembly. 3. Install bottom washer and locknut . 4. Tighten both locknuts fully and securely. 5. Tighten both left and right bolts securely. 6. Turn fork fully left to right to make sure it turns freely. A B C D B E F E A D B C STEPS (remove clamps and bolts if needed q: 1. Put handlebars into position as shown. 2.
Assembly Assembly A B C STEPS : 1. Position faceplate as shown against fork and under fork braces . 2. Install 4 screws evenly and securely so that faceplate does not move. A C B B C A STEPS (with unit up side down): 1. Position mudguard under fork so that all mounting holes line up. 2. Install two bolts and two screws evenly and securely.
Assembly Assembly B D E F F E C A C STEPS : 1. Position wheel inside fork with one bushing on each side of wheel. 2. Insert axle through fork, bushings and wheel as shown. 3. Install both washers and axle nuts fully and securely. 4. Make sure wheel spins freely. A B C D E F A B STEPS : 1. Position footrest as shown so that mounting holes line up. 2. Install 3 bolts fully and securely. 3. Repeat for opposite side.
Assembly A Connect Drive Battery : 1. Remove rear seat screw . 2. Lift up rear of seat and remove seat. 3. Locate and firmly connect drive battery connector and install battery as shown. 4. Replace seat and seat screw. A B C Assembly B C A STEPS : 1. Using included zip-tie, tie cables to fork as shown. 2. Trim excess zip-tie and push zip-tie head to back of fork leg - sharp edge can scrape or cut child.
Operation Operation C B A OPERATION (make sure child understands these instructions): • Press the Power Switch button to turn unit ON. • Adjust Throttle Grip to control speed. • Release Throttle and press and hold Brake Lever to stop the vehicle. Allow extra stopping distance in wet weather or on slopes. A B C NOTE: Driving on grass may trigger the fuse to stop the vehicle. WARNING: While riding keep both hands on the handlebars and both feet on the footrests.
IMPORTANT! Before using the unit for the first time the battery needs to be charged for at least 3.5 to 5 hours - no more than 20 hours. Once battery is depleted, recharge for 3.5 to 5 hours - no more than 20 hours. IMPORTANT! Check the drive battery and charger (supply cord, connector) for wear and damage before charging. Do not charge the battery if damage has occurred. Only replace with the same type and voltage rechargeable battery and charger supplied by the manufacturer.
Drive Battery Replacement Operation FOLLOW THESE STEPS IF THE BATTERY NEEDS TO BE REPLACED: NOTE: Batteries are installed, mounted and wired differently depending on model. Make a simple drawing on paper (or take pictures) how your battery is installed and how Red and Black wires are connected. NOTE: Access and remove Battery as shown in previous section. • Depending on the condition of the battery (i.e.: leakage) you may want to wear protective rubber gloves before removal.
GENERAL: The vehicle should be checked for damage, missing or badly worn parts before each use. If any part of the product does not operate properly – discontinue use. • Check the tightness of the fasteners before each use. Replace any fasteners that are damaged. • Inspect the product frequently. Failure to inspect the product and to make repairs or adjustments, as necessary, can result in injury to the rider or to others.
Maintenance Lithium-Ion Battery Storage and Disposal Do not leave batteries unused for extended periods of time, either in the product or in storage. When a battery has been unused for 6 months, check the charge status and charge or dispose of the battery as appropriate. STORAGE: • • • • • • Charge or discharge the battery to approximately 50% of capacity before storage. Charge the battery to approximately 50% of capacity at least once every six months.
The following are examples of potential problems. Completely read through this manual and the troubleshooting guide table before calling. If you still need help resolving the problem please contact Customer Service. NOTE: Vehicle should be turned off and fully charged before doing troubleshooting.
Troubleshooting Guide - continued Troubleshooting BEFORE YOU CALL SUPPORT: 1. 2. 3. 4. 5. 6. 7.
Radio Frequency Information (if applicable) WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device or charger/adapter complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference (2) this device must accept any interference received, including interference that may cause undesired operation.
Limited Warranty - US Warranty General: Part or model specifications are subject to change without notice. This Limited Warranty is the only warranty for the product. ALL WARRANTIES OTHER THAN STATED HEREIN ARE DISCLAIMED INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, TO THE EXTENT ALLOWABLE BY APPLICABLE LAW. ALL LIABILITY FOR INCIDENTAL, PUNITIVE, SPECIAL, OR CONSEQUENTIAL DAMAGES ARE EXPRESSLY DISCLAIMED, TO THE EXTENT ALLOWABLE BY APPLICABLE LAW.
[ USA ] PLEASE - BEFORE RETURNING TO STORE: Contact Huffy Customer Service. We are glad to assist you with any parts or assembly problems you might have! For Fast Customer Service and email: www.huffybikes.com/contact To Order Parts: www.huffybikes.com/parts OR TEL: 1 800 872 2453 (US) [ CANADA ] PLEASE - BEFORE RETURNING TO STORE: Contact Huffy Customer Service.
