Owner’s Manual for Disney Ride On This manual contains important safety, assembly, operation and maintenance information. Please read and fully understand this manual before operation. Save this manual for future reference.
Owner’s Manual Index Safety and Warnings • User and Battery Warnings....................................................................3-4 • Charging Drive Motor Warnings............................................................. 5 • Radio Frequency.................................................................................... 6 Assembly • Parts List................................................................................................. 7 • Vehicle Assembly...............................
Before using the vehicle the child must understand the controls and safety issues. They must also demonstrate the capability to handle the vehicle and operate its controls. It is the responsibility of the adult to educate the child, determine if they are fit to operate the vehicle, and supervise use.
Safety & Warnings WARNINGS - continued 4 • Do not drive into fixed objects, which may cause the wheels to spin, causing the motor to overheat. • Do not drive in very hot weather, components may overheat. • Do not allow water or other liquids to come in contact with the battery or other electric components. • Do not tamper with the electrical system. Doing so may create a short, causing the fuse to trip or other damage including fire. • Do not stand on or in vehicle while moving.
The following safety hazards may result in serious injury or death to the user of the vehicle: • Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire or explosion. Only use the supplied rechargeable battery (or suitable replacement) and charger with the vehicle. • Using the rechargeable battery and charger for any other product may result in overheating, fire or explosion. Never use the rechargeable battery and charger with another product. • Explosion.
Radio Frequency Information (charger/adapter) Safety CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device (charger/adapter) complies with Part 15 of the FCC Rules.
Parts List Parts List 9 5 6 4 7 3 2 8 1 No. QTY No. Desc. QTY No. 1 Front Wheel Desc. 2 5 Steering Wheel 1 9 2 Drive Wheel 2 6 Windshield 1 3 Drive Motor 1 7 Side Mirrors 2 4 Seat 1 8 Washer 2 Desc.
Assembly Assembly Car body hole 1 Plug B NOTE: Ensure wires are not pinched our bound up. A • Remove screw and nut from steering wheel • Install the steering wheel onto the Steering Rod end, and install the steering wheel Screw and Nut . • Tighten Screw securely. A C 1a 2 8 STEP 1: Install the Steering Wheel: • With Steering Wheel facing forward, connect the steering wheel wire plug to the plug extending out of the car body hole. • Put the connected plugs and wires down into the car body hole.
Assembly 4 Thermal Fuse 5 1. Remove axle protection caps from axles. (Ensure washer is on axle) 2. Attach both Front wheels by fitting wheels fully onto the Axle while pushing in the center hub-cap button until the wheels SNAPS into place. • It may require some additional effort to secure the wheel to the axle. Check that the wheels are secure before use. Assembly STEP 4: Install the Front Wheels: STEP 5: Connect the Battery Thermal Fuse and install Seat: 1.
Operation Open and close door: • Pull inside Latch of the door and push open. • Pull inside Latch of the door and pull closed. A Operation A A B Power on: • Press the Power Switch button to turn unit ON. • Move the Shift Lever to FORWARD to go forward when the Foot Switch is pressed. • Move the shift lever to REVERSE to go backwards when the foot switch is pressed. • Move the shift lever to STOP to stop.
Maintenance • Check the tightness of the fasteners before each use. • Check the tightness of the wheels: • Note: If the drive wheel is not tight, it will not engage the gears and the vehicle will not run. • Ensure the battery bracket is securely in place before use. • Store the vehicle indoors. Keep it away from sources of heat, such as stoves and heaters. • Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a nonwax furniture polish.
Maintenance Drive Battery Charging Interval and Time IMPORTANT! Check the drive battery and charger (supply cord, connector) for wear and damage before charging. Do not charge the battery if damage has occurred. Only replace with the same type 6V rechargeable battery and charger supplied by the manufacturer. • Only use the rechargeable battery (or equivalent replacement) and charger supplied with your vehicle. The drive battery should be charged when depleted, or if not used regularly, once a month.
The drive battery will eventually lose the ability to hold a charge. Depending on the amount of use, and varying conditions, the battery should operate for one to three years. Follow these steps to replace and dispose the battery: 1. Remove the seat. 2. Disconnect the battery connectors. 3. Remove the metal battery bracket. 4. Carefully lift the battery. • Depending on the condition of the battery (i.e.: leakage) you may want to wear protective rubber gloves before removal.
Troubleshooting Guide: Possible Cause Solution Vehicle does not run Battery low on power Recharge battery (see Battery: Recharge interval and time) Thermal fuse has tripped Let Fuse reset (approx. 5 minutes) Battery connector or wires are loose Check that the battery connectors are firmly plugged into each other. If wires are loose around the motor call Customer Service. Battery is dead Replace battery (see Battery: Replacement and Disposal) Electrical system is damaged Call Customer Service.
Your purchase includes the following limited warranty, which is in lieu of all other express warranties. This warranty is extended to the initial purchaser only. Warranty registration is not required. This warranty gives you specific legal rights: you may have other rights, which vary from state to state.
WARNING: ALWAYS WEAR YOUR HELMET WHEN RIDING THIS PRODUCT! • • • • • Helmet should sit level on your head and low on your forehead Adjust the strap sliders below the ear on both sides. Buckle the chin strap. Adjust strap until it is snug. No more than two fingers should fit between the strap and your chin. A proper fitting helmet should be comfortable and not rock forward/backward or side to side.
