User's Manual

Huf Tools
Automation · Prüftechnik · Formenbau · Kunststofftechnik · RFID Systeme · Lasertechnik
2019-06-26 G – User Manual Daimler LFSPG-MH Page 6 of 20
2. Warnings and Safety Instructions
This device must not be disposed of
in domestic waste.
Always dispose of electronics at the
designated collection facilities.
Warning! Place the device on a horizontal and stable surface and secure the connecting cables.
Otherwise there is a risk of injury due to the device falling down.
Warning! Do not look directly into the LEDs of the device for a long time,
otherwise there is a risk of eye irritation.
Warning! Only use the included power supply unit of protection class II.
Otherwise the device will lose its radio approval.
Warning! This equipment has not been designed for connection to an IT power distribution system.
Warning! The socket outlet shall be installed near the equipment and shall be easily accessible.
Warning! Do not use extension cords. Neither for the USB nor for the power cord.
Otherwise the device will lose its radio approval.
Warning! If the device, power supply unit or connecting cable is damaged,
immediately unplug the plug-in power supply unit and disconnect the device from the PC.
2.1. Disconnect Device
The low voltage socket on the back of the unit is the disconnecting device for the LFSPG-MH. To disconnect
the supply voltage, pull the extra-low voltage plug out of the device.
When not in use for a long time, unplug the AC-DC-Adapter from the wall outlet and disconnect the USB plug
from the Personal Computer.
3. Operation
The Daimler LFSPG-MH is able to read and write data from different Daimler car and truck keys.
After successful installation, as described in chapter 4, the device is ready for operation. The device status is
indicated by the upper LED, illuminate in green light when ready for operation. If the LED’s show any other
indication please refer to the Table of states on page 15.
Carry an ignition key into the key receptacle of the LFSPG-MH. The detection of the key will start
automatically. When the key is recognized the lower LED shows this by a green light.
Recent keys are detected by placing them on the lower tray. A successful detection is indicated by green light
of the lower LED.