Product Manual

Check carton for:
-Sprayer Tank with (may include Pressure Relief Valve, Quick Connect or hose adapter nut)
-Pump (A) in tank
-Hose Assembly with tting and nut (may be loose in tank)
-Shut-off Valve (B) (may be assembled to hose)
-Spray Wand (C) with Nozzle (may be loose in tank)
-Supply Tube (D)
-Instructions (E)
Here’s How to assemble your sprayer
2
If any part is missing, please call 1-800-9-SPRAYER (800-977-7293) to order a replacement.
2e. For sprayers with a poly shut-off valve/wand combination: Follow steps 2a through 2c, then:
• Insert hose into non-threaded end of handle and push all the way through the handle.
• Push hose onto end of shut-off valve. IMPORTANT: Be sure it is all the way over the barb!
• Screw handle on to the shut-off valve.
Note: This is not a compression fitting, but it is normal for it to screw on tightly.
2f. For sprayers with a poly shut-off valve: Follow steps 2a through 2c, then:
• Insert hose into non-threaded end of nut and push all the way through.
• Push hose onto end of shut-off valve:
IMPORTANT: Be sure it is all the way over the barb! Screw nut onto the control valve.
Note: This is not a compression fitting, but it is normal for it to screw on tightly.
Insert spray wand into shut-off valve. Screw cap nut to shut-off valve.
2g. For sprayers with a poly Thrustless™ shut-off valve: follow steps 2a through 2c then:
• Insert hose fitting into shut-off valve handle.
• Screw down hose nut onto handle.
• Insert spray wand fitting into shut-off valve. Screw down wand cap nut onto shut-off valve.
2a. Insert supply tube into bottom end of hose fitting.
Assemble supply tube filter to the bottom of the supply tube if so equipped.
2c. Securely thread the cap nut
onto the tank fitting. NOTE: This is
a compression fitting. It will screw
on tightly. CAUTION: make sure
the cap nut is threaded all the way
down. If loose, it may come off
with force, or spray may escape,
resulting in SERIOUS INJURY.
2b.
Insert hose into non-threaded end of nut and push all the way through. Push hose
onto hose barb. IMPORTANT: BE sure hose covers entire hose barb! If the hose is too
hard to assemble to the barb, pour hot water over the end of the hose to soften it up.
If the shut-off valve is not assembled to the hose, use section 2e, 2f, or 2g to complete your sprayer.
2d. Attach the wand to the shut-off valve.
Squeeze the handle for easier assembly.
2