Full Product Manual

Hudson® Pro® Bleach Backpack
©2020 Manufactured by H. D. Hudson
Manufacturing Company
1-800-253-4642
[e-mail]
Customer service is here to help! If you have any questions or concerns, do not return sprayer to the store.
Call 1-800-253-4642 or email [e-mail]
Connect with us!
19002
Instructions
CHANGING NOZZLE TIP INSTRUCTIONS
Changing the adjustable nozzle to the at fan or xed cone can only be accomplished while the retaining nut is tightly
fastened to the wand. The gasket is used with all of the nozzles.
Note: If the adjustable nozzle and retaining nut aren’t assembled to the wand upon opening the box, please screw it on
before switching out nozzles.
1. Unscrew the nozzle cap.
2. Unscrew the retaining nut.
3. Push the nozzle body out of the back of the retaining nut. (the gasket holds the nozzle in place in the retaining nut. If
you can’t push the nozzle body out, use a at head screwdriver to get the seal out rst).
4. Place the desired nozzle tip conguration into the retaining nut followed by the gasket.
5. Screw the retaining nut back onto the wand.
DISASSEMBLY AND CLEANING
1. Place the sprayer upright on a at surface.
3. Loosen the guide nut of the tank. Pull
the pump tube out. To inspect the seal at
the bottom of the pump, remove the piston
holder and make sure the seal is clean
and in good condition.
4. To clean the piston ring, unscrew the
guide nut, slide the seal down and o󰀨 the
piston, clean with water and insert seal
back onto the pump, and tighten again.
2. Remove rod connected
to the pump by removing the
“c” clip and pulling the rod
•
After each use, clean the tank thoroughly. If some solution remains, dispose of properly and drain tank completely.
• Follow recommendations of chemical manufacturer for proper disposal of any remaining spray solution.
• Pumping causes air to be taken in and the remaining liquid to be discharged. Pump until most of the liquid and air are
completely discharged through the nozzle.
• Rell the tank with a few quarts of soap water (a mild dish detergent is recommended) and discharge through the
nozzle. If necessary, repeat this procedure several times to ensure that the sprayer is clean.
• Sporadic spray distribution is caused by a clogged nozzle. If necessary, remove and clean nozzle.
Flat Fan
Gasket
Retaining Nut
Flat Fan Nozzle
Adjustable Nozzle
Nozzle Cap
Nozzle Body
Gasket
Retaining Nut
Fixed Cone Nozzle
Fixed Cone
Assembly
Retaining Nut
Gasket