Instructions

Instructions for 18V Lithium Ion Inator/Deator
©2019 Manufactured by H. D. Hudson
Manufacturing Company
Customer service is here to help! If you have any questions or concerns, do not return to the store.
Call 1-800-9-SPRAYER or email [e-mail]
1-800-9-SPRAYER
[e-mail]
23003-23004
Instructions
Connect with us!
Model: 23003 or 23004
Maximum pressure 160 PSI/ 11Bar/ 1100kPa
Battery Type 18V Removeable/Rechargeable Lithium Ion Battery
Automatic shut off Yes
Low pressure hose length 14 inches
High pressure tire inator hose length 32 inches
Cigar-lighter cord length 125 inches
Accessories • Tire adapter x1 • Ball adapter x1 • Raft/Mattress adapter x1
PRODUCT SPECIFICATIONS
TIRE INFLATION
WARNING: TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch is in the o position before performing any procedure.
DANGER: TO PREVENT SERIOUS INJURY OR DEATH: Do not operate Inator/Deator while car engine is running in an enclosed area.
CAUTION: TO PREVENT OVERHEATING WHILE INFLATING, keep the air intake and vents clear of obstructions. Always
wear appropriate eye protection during use.
WARNING: TO PREVENT SERIOUS INJURY FROM EXPLOSIONS: Before inating, check item manufacturer’s
recommended max air pressure. DO NOT exceed that pressure. Over ination may result in an explosion.
Note: The inator/deator has a sleep mode feature that powers o the unit after approximately 5 minutes of non-use.
Press the power button to turn the unit back on.
Note: Charge battery before use with included charger.
Notice: The inator/deator can become hot during use. Allow the unit to cool for ten minutes after each use.
Inator/deator needs to cool 30 minutes before storing away.
OPERATION
1. Insert fully charged battery into the unit.
2. Remove the high-
pressure hose from its
storage area.
3. Remove tire’s valve
cap. Move tire inator’s
lever to the up position,
insert tire adapter if
needed, then move the
lever down to lock in
place.
4. Turn unit on by turning
the power switch on high
(||).
5. Once desired pressure
is reached, simply move
the tire inator lever up
to unlock and remove.
6. Turn the unit o by moving the switch
to the center (O).
Note: Please refer to your vehicle or bicycle
manual for appropriate pressure.
BALL INFLATION RAFT/MATTRESS INFLATION
1. Insert fully charged battery into the
unit.
2. Remove the high-pressure hose
from its storage area.
3. Remove tire’s valve cap. Move tire
inator’s lever to the up position, insert
ball adapter, then move the lever down
to lock in place.
4. Turn unit on by turning the power
switch on high (||)
5. Once desired pressure is reached,
simply move the tire inator lever up to
unlock and remove.
6. Turn the unit o by moving the
switch to the center (O)
1. Insert fully charged battery into
the unit.
2. Remove the high-pressure hose
from its storage area.
3. For smaller inatables: Move tire
inator’s lever to the up position,
insert raft/mattress adapter, then
move the lever down to lock in
place.
4. For larger inatables: Remove
high-volume hose from storage,
connect it to the back of the unit
by aligning the slots in the hose
to the pins and turn the hose
counterclockwise to lock in place.
5. Insert the other end of the hose
into the inatable.
6. Turn unit on by turning the
power switch on low (|).
7. Once desired air input is
reached, simply remove the hose
from the inatable.
8. Turn the unit o by moving the
switch to the center (O).
230021 Instructions