Owners manual

Topside Controls
When you receive your new Laguna Bay Spa, it will arrive with factory
programmed settings with the clock set to Eastern Standard Time, in Normal
Mode, with a Filtration Cycle to begin at 6 PM and ending at 8 PM.
e clock displays military time. (Midnight is 00:00, Noon is 12:00, 6 PM is
18:00 and so on). e Mode Button allows you to change the factory settings;
ltration time, lter duration, and the time on the clock.
Programming
Press and hold the “M” button for 6 seconds to enter programming mode. If
no buttons are pressed for 6 seconds, the spa will exit programming mode and
resume with the programmed settings. While you are in the program menu, use
the Up or Down keys to adjust the parameters and use the ”M” key to move to
the next parameter.
e changes will be saved aer the conrmation of the last parameter only. If
there is no key pressed for 6 seconds, the system will exit the program menu
without saving the changes.
Programming the Clock Settings
Press and hold the “M” button for 6 seconds; the water
temperature will ash on the LED display followed by “rtc”
(real time clock). Use the “UP” arrow key to change the
hours. Use the “DOWN” arrow key to adjust the minutes.
In this example, the clock is set for 8:30 PM (20:30).
Press the “M” button to conrm the adjustment and move to the next parameter.
Programming the Start Time of the Filtration Cycle
Your LED will display “fst” (lter start time). e factory
settings start the lter cycle at 6 PM EST. To change the lter
start time, use the “UP” arrow button to adjust the hours and
the “DOWN” arrow button to adjust the minutes. In this
example, the ltration cycle is set to begin at 6:00 PM (18:00), the factory setting.
Press the “M” key to conrm the changes and move to the next parameter.
Programming the Filter Duration
e LED will display “ft1”. Use the “UP” arrow button to
adjust the number of hours the spa will lter. e ltration
cycles adjust in hours only, not minutes. Pressing the
“DOWN” button will not make any adjustments. In this
example, the ltration cycle is set to run for 2 hours, which is the factory setting.
Press the “M” button to move the next parameter.
rtC
20:30
Std
FSt
18:00
Std
Ft1
2:00
Std
27