Owners manual

Topside Controls
Up and Down Buttons:
e “UP” arrow button and the “DOWN” arrow button
allow you to increase and decrease the water temperature.
e LED will display the current temperature of the water
in the spa. Pressing the “UP” arrow allows you to increase
the water temperature. Pressing the “DOWN” arrow allows you to decrease the
water temperature.
Setting the Water Temperature
When you press either the “UP” or “DOWN” arrow button, the temperature on
the LED will ash. While the LED display is ashing, press the “UP” arrow to
increase the water temperature until the ashing number displays the desired
temperature. Aer 6 seconds, the LED will stop ashing. e current water
temperature will be displayed on the LED.
e “HEATER” icon will appear on the LED display and remain there
until the new temperature is reached.
To decrease the water temperature, press the “DOWN” arrow. e current water
temperature on the LED display will ash. While the temperature is ashing,
press the down arrow until the desired temperature is reached. Aer 6 seconds,
the LED will stop ashing and the water temperature will decrease to the set
temperature.
Your Home & Garden Spa is designed to retain heat and maintain water
temperature eciently and economically. It is not equipped with a cooling
device. When the outdoor temperature is high, the water in your spa may be
higher than a cool water temperature setting. During warm weather, if the water
temperature in your spa is higher than a cool temperature setting, the spa is
functioning as it is designed. If you want to cool the water in your spa, remove
the spa cover allowing the water to cool. Do not leave the spa unattended while
the cover is removed. You can also drain some of the water from the spa and add
cool water to the correct level for your spa model, making sure you adjust your
water chemistry to recommended levels.
Changing Operating Modes
Pressing the “M” button changes the modes from Energy Cost Eciency Mode
“EcoE, Filter Only Mode “Fil”, and Normal Mode “Nom. e LED will display
the current mode setting.
When the spa is in Energy Cost Eciency Mode “EcE”, press the button once to
put the spa in Filter Only Mode “Fil”. Press the button again to put the spa in
Normal Mode “Nom”.
M
26