Owners manual

Getting Started

e slice valves should always be locked in the “up” position when power

is applied to the spa. If the spa is allowed to operate when the slice valves are

closed it will damage the spa. Each time you change the water in the spa, you

should check to be sure the locks on the slice valves are in good condition; locks

should be replaced if they will not hold the “T”stem in the “up” position. Do not

use the spa until the locks have been replaced.

e Plumbing Unions connect the plumbing lines to the spa components.

When you receive the spa and each time you ll the spa with water, you should

hand tighten the plumbing unions, which loosen in transit and when seasons

change. In many cases, when there is a leak inside the spa cabinet, it is from

a plumbing union that needs to be tightened. Do not use tools or overtighten

plumbing unions as you may damage the spa.

e Filter Assembly consists of the lter, the lter basket

and the oating weir. Never use the spa without the lter

assembly in place because it will not only damage the spa

but is a drowning hazard. If any part of the lter basket

assembly is damaged, do not use the spa until it has been

replaced.

To remove the lter basket when lling the spa or

changing the lter, turn the basket counter clockwise until

it stops to unlock the basket. Li the basket assembly to

remove. Li the lter out of the lter housing. Replace

the lter, place the basket assembly over the lter housing

and turn the basket assembly clockwise until it stops and is

locked in place.

e lter basket catches large debris, the lter catches

ne particulates and oil. You should check the lter

assembly on a regular basis making sure the basket is free of debris and the lter

is in good condition. If the lter assembly is obstructed, ow will be restricted

and damage the spa. e manufacturer recommends that you replace the lter

every three months. To prevent air getting into your spa, you should soak new

lters in water for 30 minutes before installing.

e Suction Drain Covers are on the sides in the foot

well of the spa. ey are caps that cover the suction

drains that prevent debris from being sucked into

the plumbing lines. If the suction drain covers are

obstructed, ow is restricted which can damage your

spa.

It is important to check them on a regular basis to

be certain they are in good condition to help prevent

Filter Basket

Filter