Instructions

Horizontal calibration is required when the aircraft drifts on the horizontal plane

during flight. When this happens, land the aircraft and disarm its motors. Follow

the below steps to do a horizontal/gyro calibration.

1. Place the aircraft on a completely flat surface and then follow the below

calibration procedure. Hold the left stick to the right side of its socket. Rapidly and

continuously wiggle the right stick left and right until the rear LEDS flash

alternately.

2. Calibration is complete when the LED indicators stop flashing. It is

recommended that users wait for 15-20 seconds after the calibration is completed

before flying again.

3.4 Horizontal Calibration

For both configurations, flight operation is mostly the same. This

manual will describe operation on the HT012D remote as an example.

3.5 Taking Off And Landing

Rapidly and continuously

wiggle the right stick left and

right until the rear LEDS flash

alternately.

Hold the left stick to the

right side of its socket.

Start

Calibration

Complete

Takeoff

Simultaneously pull the transmitter joysticks diagonally down-out to arm the

motors (as shown in the below figure). Pull the left joystick (throttle) upwards to

takeoff.

(Note: Novice pilots are recommended to use Sport Mode 0).

Arm Motors Takeoff