Instructions

15
(1) Make sure the aircraft battery and mobile device are charged and have
adequate power.
(2) Confirm that propellers and screws are properly installed.
(3) If you are taking pictures, insert the Micro-SD card required for taking pictures
and videos.
(4) Verify that the motors arm and spin smoothly.
(5) Ensure the camera lens is clean.
(1) Pull and hold the throttle to its lowest position.
(2) Hold down the Photo key and power the transmitter on. The transmitter’s status
LED will flash red; please do not press or touch any other keys, buttons or sticks
while this process is ongoing. Users may let go of the Photo key and throttle.
Connect the aircraft to its battery and allow it to bind to the transmitter. The two
must be very close to each other; when the bind is successful, the binding status LED
will turn green.
(1) Pull and hold the throttle to its lowest position.
(2) Hold down the binding key and power the transmitter on. Users may let go of
the binding key and throttle. Please do not press or touch any other keys, buttons
or sticks while this process is ongoing, or the aircraft may exhibit instability while
flying.
3.2 Pre-Flight Checklist
3.3 Binding
3.3.1 Binding The HT012D And Aircraft
3.3.2 Binding The HT011 And Aircraft
Mode 2 depicted
Mode 2 depicted