Installation & Assembly

42409

ASSEMBLY & INSTALLATION INSTRUCTIONS

Sprig Sconce 206050

B405

(Figure 1)

MACHINE

SCREWS

To Install Fixture (Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

3 OF 4

CAUTION: MAKE SURE WIRE CONNECTORS

ARE TWISTED ON SECURELY, AND NO

BARE WIRE IS EXPOSED.

1. Carefully unpack the xture (A) from the

carton.

2. Thread two studs (D) into the appropriate

holes in the crossbar (B) that align with xture

(A) and desired orientation.

3. Using two machine screws (not provided)

attach crossbar (B) to the electric box using

outer oval holes to orient xture.

Note: A new electric box comes with screws.

When replacing a fixture, retain the existing

screws for use with the new fixture.

4. Adjust the studs (D) to proper length to

ensure the xture will t snugly against the

wall.

5. Using suitable wire connectors (not provided)

connect fixture wires to supply (white to white

and black to black). Attach a pigtail lead to

the crossbar ground screw (C). Connect all

ground wires (bare copper or green to bare

copper or green).

6. Carefully tuck all wires behind xture, push

xture rmly against the wall and fasten by

threading knobs (E) on to studs (D).

Note: Be sure no wires are pinched between

the wall and the fixture. Be sure threaded

studs are fully seated in knobs.

7. See instructions on next page for installing

glass.