Installation Instructions

Glass Installation Instructions C71
Pluto Floor Lamps 242210 & 242210C
Modern American Blacksmiths | Fine, Hand-Crafted Lighting
Castleton, Vermont USA | HUBBARDTONFORGE.COM 32392 Rev A
To Install Bulb & Glass (Figures 1 & 2)
Component Parts
A Fixture
B Socket
C Glass
D Screw
E Steel Washer (2)
F Rubber Washer (2)
G Nut
H Cap
I Dimmer Rod
J Dimmer Knob
1. Carefully unpack the lamp from the carton.
2. Apply a drop of the supplied thread locking compound
to the internal threads at the top of the dimmer knob (J).
Run dimmer rod (I) down thru grommets and thread into
dimmer knob (J). Note: Application of the thread locking
compound is necessary to prevent the dimmer rod from
loosening. Be certain to apply the compound.
3. Install bulb. (not included) Bulb is included with the “C”
version.
4. Unthread cap (H) from screw (D). (shipped installed on fixture)
5. Remove nut (G), first steel washer (E), and first rubber washer
(F) from screw (D). Save for later use. Parts ship installed.
6. Slip screw (D) with steel and rubber washer (E&F) up through
hole in glass (C).
7. Slide remaining rubber washer (F) onto screw (D) followed
by steel washer (E). Thread nut (G) onto screw (D) and tighten.
(Figure 1)
Note: Be sure not to over tighten the nut.
8. Tilt glass (C) over bulb. Slide screw (D) up through hole in
top of fixture (A). Thread cap (H) onto end of screw (D) to
secure glass (C). (Figure 2)
9. Repeat steps for remaining piece of glass.
If you need further assistance, or find that you are missing any parts, please contact the
dealer from which you purchased this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper
installation, lamping or use of this fixture.
(Figure 1)
(Figure 2)