Installation Instructions

HUBBARDTONFORGE.COM
-, -   
154 RT. 30 SOUTH
CASTLETON, VERMONT 05735
31616
Glass Installation Instructions
If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your xture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.
To Install Bulb & Glass (Figures 1 & 2)
Component Parts
A Fixture
B Socket
C Glass
D Screw
E Steel Washer (2)
1. Carefully unpack the lamp from the carton.
2. Unthread cap (H) from screw (D).
3. Remove nut (G), rst steel washer (E), and rst rubber
washer (F) from screw (D). Save for later use. Parts ship
installed.
4. Slip screw (D) with steel and rubber washer (E&F) up
through hole in glass (C).
5. Slide remaining rubber washer (F) onto screw (D) followed
by steel washer (E). Thread nut (G) onto screw (D) and
tighten. (Figure 1)
Note: Be sure not to over tighten the nut.
6. Install bulb. (not included) Bulb is included with the “C” ver-
sion.
7. Tilt glass (C) over bulb. Slide screw (D) up through hole in
top of xture (A). Thread cap (H) onto end of screw (D) to
secure glass (C). (Figure 2)
C67
Pluto Table Lamps 274120 & 274120C
Page 1 of 1
(Figure 1)
D
E
F
C
F Rubber Washer (2)
G Nut
H Cap
(Figure 2)
G
H
B
D
A
C

Summary of content (1 pages)