Installation Instructions

ManualsBrandsHubbardton Forge ManualsLightingPlanar 1 - Light Single Geometric LED Pendant

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.

We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.

HUBBARDTONFORGE.COM

-, -   

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

32565A

Assembly & Installation Instructions

A387

Planar Linear Pendant 139720D

Page 2 of 3

Assemble Canopy Pipes to Ceiling Bracket (Continued)

Note: If installing on a sloped ceiling, make certain that notches in

swivel (P) are oriented toward the lower side of the slope.

Complete Fixture Assembly (Figures 3 & 4)

Component Parts

A Fixture Pipe (2)

C Hex Nipple

F Canopy Pipe (2)

G Clutch (2)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX

PRIOR TO INSTALLATION.

1. Line up holes in Canopy (H) with xture pipes (A). Slide

over xture pipes (A) until canopy (H) rests on top of xture.

2. Thread the wires from the xture pipe (A) into and through

the canopy pipe (F) up through the hex nipple (C).

3. Unscrew the clutch (G) from the canopy pipe (F); slide it

across the wires and onto the xture pipe (A). Follow this

with the plastic clutch sleeve (I), oriented so the tapered end

of the clutch sleeve nests in the clutch. Repeat for second

set of pipes. (Figure 3).

4. Slide the canopy pipe (F) as far as necessary to set desired

total length of xture. Be careful not to scratch the pipe

surfaces and to pull excess wire up through the canopy

pipe (F). Screw clutch (G) onto canopy pipe (F). There must

be a minimum 1-1/2" of inner pipe inside the outer pipe.

Hand-tighten the clutch to temporarily hold this adjustment.

The clutch is not securely fastened at this point; do not de-

pend on it to hold the xture. Repeat for both pipes.

Important: To ensure full connection strength, be sure the tapered

end of the plastic clutch sleeve is oriented toward the clutch when

assembled and securely tighten set screw (Figure 3).

5. Continue with Ceiling Installation.

(Figure 3)

H Canopy

I Plastic Clutch Sleeve (2)

J Set Screw (2)

(Continued)

LARGE DIAMETER PIPE

CLUTCH

PLASTIC CLUTCH SLEEVE

(Figure 4)