Installation & Assembly

ManualsBrandsHubbardton Forge ManualsLightingPillar 1-Light Armed Sconce

HUBBARDTONFORGE.COM

-, -   

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

32435

Assembly & Installation Instructions

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this

product. We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.

These instructions are to be used for the following fixtures:

To Prepare & Install Fixture (Figure 1)

Component Parts

A Fixture

B Mounting Bracket

C Anchors (4)

D #10 Screws (4)

E Ground Screw

F Cupped Washer

G #8 Black Screws (4)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX

PRIOR TO INSTALLATION.

1. Carefully unpack the xture from the carton.

2. Place the mounting plate (B) over the electrical box being

sure to hold it plumb and level. With a pencil, mark the loca-

tion of all mounting holes in the mounting plate (B) on the

wall behind. Set mounting plate aside.

3. Drill 1/4" holes in the locations marked on the wall. For holes

using anchors, place the tapered end of the anchors (C) into

the holes and gently tap them ush to the wall using a light

weight hammer.

B336

For Pillar Sconces: 1lt 204420 & 3lt 204423L&R

Page 1 of 2

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

(Continued)

Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If installing in a non-wood

frame application, we recommend consulting a qualified builder or electrician.

Please Note: After installation, extra hardware and accessories may be left due to kits being used on multiple products.

(Figure 1)

Summary of content (2 pages)

PAGE 1
B336 Assembly & Installation Instructions For Pillar Sconces: 1lt 204420 & 3lt 204423L&R Page 1 of 2 CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
B336 Assembly & Installation Instructions For Pillar Sconces: 1lt 204420 & 3lt 204423L&R Page 2 of 2 To Prepare & Install Fixture (Figure 1) (Continued) 4. Thread the wires in the electrical box through the hole in the mounting plate (B) while moving the plate into position. Using the 1" #10 screws (D), screw the mounting plate securely to the wall. Be careful not to over-tighten or strip the anchors. (Figure 2) I 5.