Installation & Assembly

MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING
CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM
40145
ASSEMBLY & INSTALLATION INSTRUCTIONS
Penumbra Pendant 139810
A528
To Install Fixture (Figure 2)
PAGE 4 OF 5
1. Locate the positive (+) label on top of the xture (H).
2. Align the positive (+) sticker on the xture (H) with the positive (+) sticker on the gripper (J).
3. Push the support/supply cable (I) from the positive (+) side of the xture (H) into the positive (+) gripper (J). Push the
cable (I) in far enough so that the cable (I) exits the side of the gripper (J).
4. Repeat step 3 for the remaining supply/support cable (I) and gripper (J).
5. Adjust xture (H) to desired height by pressing in the plunger on the gripper and pushing/pulling the supply/support
cables (I) as necessary.
6. Once the xture (H) is at the desired height cut the supply/support cables (I) as close to the notch in the gripper (J) as
possible.
7. Follow instructions on the following page to complete installation.
(Figure 2)
A
I
J
PLUNGER
H
CAUTION: ONCE EXCESS CABLE IS CUT, FIXTURE CANNOT BE LOWERED.
CAUTION: BE SURE NO PIECE OF THE SUPPORT CABLE IS TOUCHING THE FIXTURE.