Installation & Assembly

ManualsBrandsHubbardton Forge ManualsChandeliersPenumbral 1-Light Unique / Statement Wagon Wheel Chandelier

MODERN AMERICAN BLACKSMITHS | FINE, HAND CRAFTED LIGHTING

CASTLETON, VERMONT USA | HUBBARDTONFORGE.COM

40145

ASSEMBLY & INSTALLATION INSTRUCTIONS

Penumbra Pendant 139810

A528

To Attach to Ceiling (Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

(Figure 1)

Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.

PAGE 3 OF 5

1. Carefully unpack the xture from the carton.

2. Locate canopy assembly. Remove cap (C) and canopy

cover plate (B) and set aside for later use.

3. Thread the wires in the electrical box through the hole in

the canopy (A) while moving the canopy into position.

Using two machine screws (not provided) fasten canopy

(A) to the electric box.

Note: Position the canopy so that the grippers are in line with the

desired direction of your fixture.

Note: A new electric box comes with screws. When replacing a

fixture, retain the existing screws for use with the new fixture.

4. Lift canopy cover plate (B) up to the bottom of canopy (A)

allowing the threaded nipple (D) to come through the hole

in the center of the canopy cover plate (B).

5. Screw the cap (C) onto the threaded nipple (D) to hold the

canopy cover plate (B) to the bottom of the canopy (A).

Adjust the height of the threaded nipple (D) until the cap

bottom of the canopy (A).

6. Remove cap (C) and canopy cover plate (B) from threaded

nipple (D). Tighten lock nut (E) to inside of canopy (A).

This will lock the height of the threaded nipple (D)

7. Attach a pigtail lead to the canopy (A) using the provided

ground screw (F) and cupped washer (G) in kit bag.

8. Using suitable wire connectors (not provided) connect

driver wires to supply wires (white to white and black to

black). Holding canopy cover plate (B) close to canopy (A),

connect all ground wires (bare copper or green to bare

copper or green) together.

9. Raise canopy cover plate (B) to the bottom of canopy (A)

and secure with cap (C), being sure no wires are pinched

between canopy (A) and the ceiling.

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED

ON SECURELY, AND NO BARE WIRES ARE EXPOSED.

MACHINE

SCREWS