Installation & Assembly

Installation Instructions A470
Otto Small Sphere Pendant Track Version 161305T Page 8 of 8
Modern American Blacksmiths | Fine, Hand Crafted Lighting
Castleton, Vermont USA | HUBBARDTONFORGE.COM 36888
Problem: Lights burn out quickly or burn very brightly:
Diagnosis: Bad Socket Connection.
Corrective action: Inspect Lamp Pins and socket contacts for evidence of discoloration.
Replace if discolored.
Diagnosis: Finger Oils on Quartz Lamps
Corrective action: Wipe Glass clean with clean soft cloth on all Lamps after installation.
Problem: System comes on but Lights flicker or are dim:
Diagnosis: Wrong Lamps installed. 24 Volt Lamps operating on 12 Volt Power Supply.
Corrective action: Replace 24 Volt Lamps with 12 Volt Lamps.
Problem: Lamps become dim or flicker after operating normally over a period of time
Diagnosis: Deteriorating 12 Volt connections due to high current.
Corrective action: Recheck all secondary connections, looking for discoloration, oxidation or hot
spots. Tighten any loose connections. Replace Pendant leads if contacts are discolored.
Problem: Circuit Breaker on main panel trips on initial power up:
Diagnosis: Electrical Short on 120 volt side of the Transformer.
Corrective action: Check all connections and repair if needed, then confirm operation.