Installation & Assembly

Installation Instructions A470
Otto Small Sphere Pendant Track Version 161305T Page 5 of 8
Modern American Blacksmiths | Fine, Hand Crafted Lighting
Castleton, Vermont USA | HUBBARDTONFORGE.COM 36888
To Install Glass (Figure 2)
1. Install bulbs (D) (not included).
2. Screw glass tube (E) in the socket cup
until it stops.
Note: you can screw the glass tube (E)
into either socket cup to start.
3. While holding the glass tube (E) at an
upward angle, slide the mesh tube (F)
over the glass tube.
4. Keeping the upward angle, slide the
glass globe (G) over the mesh tube (F)
until the mesh tube (F) travels through
the openings at both ends of the glass
globe (G)
5. Screw the remaining socket cup into the
exposed end of the glass tube (E) until it
stops.
Note: Screw in the socket cup by
holding onto the brass ball.
Note: To orient the seam in the mesh
tube, lift the glass globe by holding the
brass balls on each end. While tension
is relieved in the cable rotate the entire
globe until the mesh tube is oriented in
the desired position.
6. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 2)