Installation & Assembly

Installation Instructions A470
Otto Small Sphere Pendant Track Version 161305T Page 3 of 8
Modern American Blacksmiths | Fine, Hand Crafted Lighting
Castleton, Vermont USA | HUBBARDTONFORGE.COM 36888
To Install Track Adapter (Figure 1)
Caution: Be sure power is off at the main breaker box prior to installation
1. Carefully unpack the fixture (C)
from the carton.
2. Determine desired finished height
of fixture (C).
3. Using a sharp pair of cutters, cut
the end of the supply/support
cable (B) off square and clean at
the desired length. This will
change the profile of the end of the
supply/support cable (B) and
prepare it for insertion into the
track adapter (A).
NOTE: Cutting the cables at
different lengths will cause the
fixture to hang with one side higher
or lower. To hang fixture level, cut
both cables at the same length.
4. Follow the instructions on the
included instruction sheet:
Installation Instructions for Edge
Lighting Fast Jack Male Coaxial
Fixture Connector, document #
904-FJ-MC-04.
(Figure 1)
(
Continued
)